Just Water -- Frequently Asked Questions
The first time I used the filter I saw small specks of black in the filtered water?
The first time the filter is used there will be some carbon dust or very tiny particles that will be in the filtered water. This is normal and the water is safe to drink. These will disappear after the filter has been used for the first time.
Can I hold onto the ceramic shell when I am tightening the filter and the wing nut?
NO. You can stress the ceramic shell and it can break or crack. If this happens then the filter is no longer doing its job correctly. Bacteria can pass through the crack and into the lower bucket.
Hold the filter by its base when tightening the wing nut.
Maintenance
How do I clean the filter?
Use any type of abrasive pad (not metal) and gently wipe the surface of the filter. Then rinse with water.
*** DO NOT USE SOAP OF ANY KIND TO WASH THE FILTER ***
How often should I clean the buckets?
Clean the buckets before the first use. Use a bleach solution of 8 drops to one gallon of water. Be sure to NOT use any bleach that is scented.
After you have begun to use the buckets they should be cleaned at least once a month. Use filtered water when making the cleaning solution.
How do I clean the sock?
Rinse with water.
***DO NOT USE SOAP ***
Are there any precautions I should take when cleaning or changing the filter?
If possible, wear gloves. The surface of the filter might be contaminated with the bacteria that have been filted out of the water. If you are not able to wear gloves, wash your hands with warm water and soap and use hand sanitizer.
BugOut Travel Bottle
How do I use the bottle the first time?
1. Remove the bottle from its plastic bag.
2. Unscrew the lid, remove paper instructions, and fill with water.
3. Allow a few minutes for the filter to become saturated with water.
4. Try to pull water through the filter, up the straw and out the mouthpiece. Slightly squeeze the bottle to put pressure on the filter.
5. When you are able to pull water through the mouthpiece, you might have a small amount of charcol dust or chips with the first mouthful of water. This is normal and safe.
6. As the filter and charcol become completely saturated with water, the flow rate will increase slightly.
7. Do not turn the bottle upside down, as it will leak.
How do I clean the bottle's filter?
1. Unscrew the lid and remove the filter from the bottle.
2. *** DO NOT REMOVE THE STRAW FROM THE LID OR THE CONNECTOR FROM THE STRAW ***
3. Do not remove the filter from the straw. Hold onto the base of the filter and use a soft abrasive pad (not metal) to gently rub the surface of the filter.
4. Rinse with water.
5. Fill bottle with water and place filter into the bottle and screw on the lid.
6. emergency water filter, diy water filter